Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Durango Citadel, 3.6L Eng VIN G, AWD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both Axles | 1.8 | B | ||
| Front Axle | 1.0 | B | ||
| Rear Axle | 1.0 | B | ||
| Combination Procedure: AXLE SEAL: Replace: | ||||
| Rear,One Side | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | Includes: Bleed System. | 0.3 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| Front,Dual Piston Calipers,One Side | 0.7 | B | ||
| Rear,Single Piston Caliper,One Side | 0.5 | B | ||
| w/Brembo Brakes | Not Serviceable. | B | ||
| Combination Procedure: CALIPER: Replace: | ||||
| One | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: | ||||
| Both Sides | 0.9 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| AWD, Front,Hub and Bearing Assembly,One Side | 0.5 | B | ||
| Rear,One Side | Includes: R&I Knuckle Assembly. DOES NOT include wheel alignment. | 2.4 | B | |