LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating & Air Conditioning (Service Information) >> Controls, Front >> Transducer, A/C Pressure >> Removal

Transducer, A/C Pressure: Removal

NOTE:

It is not necessary to discharge the refrigerant system to replace the A/C pressure transducer.

GC0082715Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical A/C pressure transducer and refrigerant line shown.

  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the wire harness connector (1) from the A/C pressure transducer (2) located on the A/C discharge line (3).
  3. Remove the A/C pressure transducer from the fitting on the A/C discharge line and remove and DISCARD  the O-ring seal.
scientia non olet · About LEMON Manuals