Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| Esim Signal Circuit Shorted To Ground |
| Esim Signal Circuit Shorted To The Esim Ground Circuit |
| Pinched/Obstructed Line Between The Intake Manifold And Charcoal Canister |
| Purge Solenoid Stuck Closed |
| Evaporative System Integrity Monitor (Esim) Switch Stuck Closed |
| Powertrain Control Module (Pcm) |
Always Perform The Pre-Diagnostic Troubleshooting Procedure Before Proceeding. Refer To PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .