Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| Evap Purge Solenoid Vacuum Supply |
| Evap Purge Tube Obstruction |
| Obstruction In The Vent Hose Or Filter |
| Esim Orientation Or Installed Incorrectly |
| Large Evaporative Emission Leak |
| Esim Signal Circuit Open |
| Esim Ground Circuit Open |
| Evaporative System Integrity Monitor (Esim) Switch Stuck Open |
| Evap Purge Solenoid |
| Powertrain Control Module (Pcm) |
Always Perform The Pre-Diagnostic Troubleshooting Procedure Before Proceeding. Refer To PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .