LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (3.6L Emissions Control) >> Evaporative Emissions >> Sensor, Fuel Tank Pressure >> Installation

Sensor, Fuel Tank Pressure: Installation

WARNING: This page is about a different variant/trim than selected.
GC0145300Courtesy of CHRYSLER GROUP, LLC
  1. The fuel tank pressure sensor seal (1) can be reused if not damaged.
    GC0175211Courtesy of CHRYSLER GROUP, LLC
  2. Install the fuel tank pressure sensor (3) into the fuel tank and seat the retaining clips (2).
  3. Connect the fuel tank pressure sensor wire harness connector (1).
  4. Install the fuel tank. Refer to INSTALLATION
  5. Connect the negative battery cable.
scientia non olet · About LEMON Manuals