LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Lubrication >> Pick-Up, Oil Pump >> Installation

Pick-Up, Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.
GC0145015Courtesy of CHRYSLER GROUP, LLC
  1. Lightly lubricate the new O-ring seal (1) with engine oil and install on the oil pick-up tube.
    GC0145016Courtesy of CHRYSLER GROUP, LLC
  2. Install the oil pick-up tube (1) with two bolts (2 and 3). Tighten the bolts to 12 N.m (106 in. lbs.).
  3. Install the oil pan. Refer to PAN, OIL, INSTALLATION .
  4. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to STANDARD PROCEDURE - ENGINE OIL AND FILTER CHANGE  .
  5. Connect the negative battery cable and tighten nut to 5 N.m (45 in. lbs.).
  6. Run the engine until it reaches normal operating temperature.
scientia non olet · About LEMON Manuals