Jet, Piston Oil Cooler: Installation
WARNING: This page is about a different variant/trim than selected.
- Lubricate a NEW
O-ring seal (1) with engine oil and install on the piston oil cooler jet(s).NOTE:
Piston oil cooler jet for cylinders one/two shown. Piston oil cooler jets for cylinders three/four and five/six are similar.
- Install the piston oil cooler jet(s) (2) into the engine block and tighten the retaining bolt (1) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Install the crankshaft. Refer to INSTALLATION
- If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to .
- Fill the cooling system. Refer to COOLANT SYSTEM AIR EVACUATION
- Run the engine until it reaches normal operating temperature. Check the cooling system for the correct fluid level. Refer to STANDARD PROCEDURE .