LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Lubrication >> Diagnosis And Testing >> Checking Engine Oil Pressure

Checking Engine Oil Pressure

WARNING: This page is about a different variant/trim than selected.
multimedia:A supplement to the article is available.
  1. Remove the oil filter and cap. Refer to REMOVAL 
  2. Transfer the oil filter to the (special tool #2021500090, Adapter, Late Version 3.6L Oil Pressure Test)
  3. Install Pressure Gauge (special tool #C-3292A, Gauge, Pressure) (1) to the Oil Pressure Test Adapter.
  4. Install the Oil Pressure Test Adapter to the engine and securely tighten.
  5. Start and idle the engine. If oil pressure is 0 at idle, shut off the engine and consult the Engine Lubrication and Diagnostic Table. Refer to ENGINE LUBRICATION DIAGNOSTIC TABLE  .
  6. Run the engine until it reaches normal operating temperature.
  7. Verify that the engine has acceptable oil pressure. Refer to ENGINE SPECIFICATIONS  .
scientia non olet · About LEMON Manuals