Insulator, Engine Mount, Right: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect and isolate the negative battery cable.
Remove the upper intake manifold and insulator. Refer to MANIFOLD, INTAKE, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the bolts (1) and the engine mount heat shield from both the left and right engine mounts.

Courtesy of CHRYSLER GROUP, LLC
Remove both the left and right engine mount nuts (1).
multimedia:A supplement to the article is available.

NOTE:
Do not place the engine support fixture on the fenders. The engine support fixture must be placed on the inner body structure.

Courtesy of CHRYSLER GROUP, LLC
Remove the closeout panels and place the engine support fixture as shown on the right side of the inner body structure (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the closeout panels and place the engine support fixture as shown on the left side of the inner body structure (1).

Courtesy of CHRYSLER GROUP, LLC
Install the Engine Support Fixture (1) (special tool #8534C, Fixture, Driveline Support) and carefully lift the engine only high enough to gain enough clearance to remove the mount.

Courtesy of CHRYSLER GROUP, LLC
Remove the two bolts (1) from the right engine mount isolator and remove the isolator from the vehicle.
If required, remove the four bolts from the right engine mount bracket and remove the bracket from the vehicle.