Seal, Crankshaft Oil, Front: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the accessory drive belt and the crankshaft vibration damper. Refer to REMOVAL NOTE:
Take note of the front oil seal orientation prior to removal.
- Install the sleeve (2) from Seal Remover (special tool #8511, Remover, Seal) around the flywheel key (1) and onto the nose of the crankshaft.
- Screw Seal Remover (special tool #8511, Remover, Seal) (1) into the front crankshaft oil seal (2).
- Install the extractor screw (2) into the Seal Remover (special tool #8511, Remover, Seal) (1). Hold the seal remover stationary and tighten the extractor screw against the sleeve until the front crankshaft oil seal (3) is removed from the engine timing cover.