LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (3.6L Engine (Service Information)) >> Cylinder Head >> Solenoid, Variable Valve Lift >> Removal >> Bank 1 Solenoid 2

Bank 1 Solenoid 2

WARNING: This page is about a different variant/trim than selected.
  1. Remove the upper intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
    GC0173650Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the wire harness connector (1) from the Variable Valve Lift (VVL) solenoid.
  3. Remove the VVL solenoid retaining bolt (2).
  4. Remove the VVL solenoid from the cylinder head.
  5. The O-ring seal can be reused if not damaged.
scientia non olet · About LEMON Manuals