LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (6.4L Engine (Service Information)) >> Valve Timing >> Phaser, Camshaft >> Removal

Phaser, Camshaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the timing chain cover. Refer to COVER(S), ENGINE TIMING, REMOVAL .
  3. Loosen, but do not remove the camshaft phaser retaining bolt.
  4. Remove the timing chain tensioner. Refer to TENSIONER, ENGINE TIMING, REMOVAL .
    GC0184486Courtesy of CHRYSLER GROUP, LLC
  5. Ensure that the camshaft gear is aligned with the camshaft timing chain marks (1) in the twelve O'clock position and the engine is at Top Dead Center (TDC) on the compression stroke.
    GC0184451Courtesy of CHRYSLER GROUP, LLC
  6. Remove the camshaft phaser retaining bolt (1).
    GC0184479Courtesy of CHRYSLER GROUP, LLC
  7. While lifting upwards on the timing chain (1) remove the camshaft phaser from the camshaft.
scientia non olet · About LEMON Manuals