Exhaust Manifolds

WARNING: This page is about a different variant/trim than selected.

NOTE:

Left side shown. Right side similar.

Courtesy of CHRYSLER GROUP, LLC

Clean the sealing surfaces of the exhaust manifold (1) and cylinder head.
Using a new exhaust manifold gasket. Position gasket onto the cylinder head.
Loosely install the exhaust manifold bottom row of bolts (3) and tie bars (2).
Using care not to damage the exhaust manifold gasket. Position the exhaust manifold onto the bolts between the gasket and the tie bars.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
The studs are stainless steel and must be installed in the same location as removed.
Install the exhaust manifold (2) top row of bolts (3) and stainless steel studs (1).

Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown. Tighten the exhaust manifold bolts and studs to the proper specifications. Refer to TORQUE SPECIFICATIONS .
Install the exhaust manifold heat shield. Tighten nuts to the proper specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Install the cylinder head. Refer to INSTALLATION

Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable (1).
Start the engine and check for leaks.