LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2020 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Muffler, Exhaust >> Installation >> 3.6L Dual Exhaust

3.6L Dual Exhaust

GC0190432Courtesy of CHRYSLER GROUP, LLC
NOTE:

Muffler installation is a two-man operation.

  1. Install the muffler and tailpipe (2) assembly in vehicle and tighten the four spring nuts (1) to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
    GC0190504Courtesy of CHRYSLER GROUP, LLC
  2. Install the two exhaust isolators (1) to the muffler.
    GC0190443Courtesy of CHRYSLER GROUP, LLC
  3. Install the two rear exhaust isolators (1).
    GC0190520Courtesy of CHRYSLER GROUP, LLC
  4. Install the rear exhaust isolators (1).
  5. Install the ground strap (2).
  6. Install the rear exhaust isolators (1).
    GC0190447Courtesy of CHRYSLER GROUP, LLC
  7. Install the left rear exhaust isolator (1).
  8. Install the left exhaust resonator. Refer to RESONATOR, EXHAUST, INSTALLATION .
  9. Make sure the muffler/tailpipe assembly is correctly positioned and the properly aligned. The minimum clearance between components is 25 mm (1 inch).
  10. Remove the jack supporting the exhaust system.
  11. Remove the support and lower the vehicle.
  12. Start the engine and inspect for exhaust leaks. Repair exhaust leaks as necessary.
scientia non olet · About LEMON Manuals