Front Half Shaft: Installation

Courtesy of CHRYSLER GROUP, LLC

Using axle seal protector (special tool #10270, Protector, Half Shaft, Drive) (1), install halfshafts in the axle. Verify halfshaft has engaged.
NOTE:
Use care when removing seal protector to prevent damaging the seal.

Courtesy of CHRYSLER GROUP, LLC
Install NEW coated washer on the outer C/V joint shaft.
Install halfshaft (1) through the hub/bearing (2).
Install shock clevis on lower control arm and tighten nut to the proper specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Install upper control arm on knuckle and tighten ball joint nut to the proper specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Install tie rod end (1) on knuckle and tighten to the proper specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .
Install stabilizer link (7, 5) on lower control arm and tighten to the proper specifications. Refer to FRONT, TECHNICAL SPECIFICATIONS .
Install caliper on caliper adapter. Refer to CALIPER, DISC BRAKE, INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Install wheel speed sensor (1) on the hub/bearing (3).
NOTE:
Always install a NEW hub nut. The original hub nut is one-time use only and should be discarded when removed.
Install a NEW halfshaft hub/bearing nut and tighten to. Refer to TORQUE SPECIFICATIONS .
Install the wheel and tire assemblies.
CAUTION:
Before moving vehicle, pump brake pedal several times to ensure vehicle has a firm brake pedal to adequately stop vehicle.
Pump brake pedal until caliper pistons and brake pads are seated and a firm brake pedal is obtained.