Lamp, Center High Mounted Stop: Removal

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the battery negative cable.
2. Remove the spoiler (1) and Center High Mounted Stop Lamp (CHMSL) (2) from the liftgate flip-up glass as a unit. Refer to SPOILER, REMOVAL .
3. Reach through the opening on the liftgate side of the spoiler to access and disconnect the wire harness connector (3) from the connector receptacle on the back of the CHMSL housing.
4. Remove the two screws (4) that secure the CHMSL to the spoiler.
5. Remove the CHMSL from the spoiler.