DECKLID/Hatch/Liftgate/Tailgate/Swing Gate: Liftgate: Adjustments: In/Out

Courtesy of CHRYSLER GROUP, LLC

1. Using a trim stick (special tool #C-4755, Trim Stick) or equivalent, remove the upper rear headliner trim (2).

   Courtesy of CHRYSLER GROUP, LLC

2. For the upper lift gate adjustments, loosen the six hinge to header fasteners (2 and 3) and adjust to specifications Refer to GAP AND FLUSH, SPECIFICATIONS .
3. Tighten the hinge bolts to 28 N.m (21 ft. lbs.).

   Courtesy of CHRYSLER GROUP, LLC

4. For the lower lift gate adjustments, remove lifgate scuff trim, Refer to PLATE, SCUFF, LIFTGATE, INSTALLATION .
5. Loosen the striker screws (2) and adjust to specifications Refer to GAP AND FLUSH, SPECIFICATIONS .
6. Tighten the striker screws to 28 N.m (21 ft. lbs.).
7. Position the upper rear headliner trim and seat fully.
8. Position liftgate scuff plate trim and seat fully.