Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on.
2. With the scan tool, read ADCM DTCs and record on the repair order.
3. With the scan tool, erase DTCs.
4. Start the Engine.
5. With the scan tool, read ADCM DTCs.
  Is the DTC active?
  
  Yes
  - Go To 2
  No
  - Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
RIGHT FRONT ACCELERATION SENSOR
NOTE:
Make sure the Acceleration Sensor harness connector is connected correctly.
1. Turn the ignition off.
2. Verify the Acceleration Sensor is mounted correctly.
3. Inspect the Acceleration Sensor harness connector for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Wiggle test the wiring harness and connectors while monitoring the scan tool data relative to this circuit.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ADCM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Active Damping Control Module (ADCM) in accordance with the Service Information. Refer to MODULE, ACTIVE DAMPING CONTROL (ADCM), REMOVAL .
  - Perform the ADCM VERIFICATION TEST. Refer to STANDARD PROCEDURE .