LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (3.6L Engine (Service Information)) >> Lubrication >> Sensor, Oil Pressure >> Removal

Sensor, Oil Pressure: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the upper intake manifold and lower intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .
    GC0173574Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the oil pressure sensor wire harness connector (1).
    GC0173640Courtesy of CHRYSLER GROUP, LLC
  3. Remove the oil pressure sensor (1) from the oil filter housing.
scientia non olet · About LEMON Manuals