LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (3.6L Engine (Service Information)) >> Lubrication >> Jet, Piston Oil Cooler >> Removal

Jet, Piston Oil Cooler: Removal

WARNING: This page is about a different variant/trim than selected.
GC0144300Courtesy of CHRYSLER GROUP, LLC
NOTE:

Piston oil cooler jet for cylinders one/two shown in illustration. Piston oil cooler jets for cylinders three/four and five/six are similar.

  1. Remove the crankshaft. Refer to CRANKSHAFT, REMOVAL .
  2. Remove the bolt (1) and the piston oil cooler jet(s) (2) from the engine block.
    GC0144299Courtesy of CHRYSLER GROUP, LLC
  3. Remove and discard the O-ring seal (1) from the piston oil cooler jet(s).
scientia non olet · About LEMON Manuals