Seal, Crankshaft Oil, Front: Installation
WARNING: This page is about a different variant/trim than selected.
- Position the front crankshaft oil seal (3) to engine timing cover.
- Align the Front Crankshaft Seal Installer (special tool #10199, Installer, Crankshaft Front Oil Seal) (1) to the flywheel key on the crankshaft and against the front crankshaft oil seal (3).CAUTION:
Only tighten the crankshaft vibration damper bolt until the oil seal is seated in the cover. Overtightening of the bolt can crack the front timing cover.
- Install and tighten the crankshaft vibration damper bolt (2) until the crankshaft oil seal is seated in the engine timing cover.
- Install the crankshaft vibration damper. Refer to INSTALLATION .
- Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .