LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (3.6L Engine (Service Information)) >> Engine Block >> Ring(S), Piston >> Removal

Ring(S), Piston: Removal

WARNING: This page is about a different variant/trim than selected.
GC0144293Courtesy of CHRYSLER GROUP, LLC
NOTE:

Typical piston shown in illustration.

  1. Remove the piston and connecting rod(s). Refer to REMOVAL .
    CAUTION:

    To avoid damage to the piston rings, they must be removed in the following order:

    • No. 1 (upper) piston ring (1)
    • No. 2 (intermediate) piston ring (2)
    • Oil ring upper side rail (3)
    • Oil ring lower side rail (4)
    • Oil ring expander (5)
    GC0081636Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Typical piston shown in illustration.

  2. Remove the No. 1 (upper) piston ring using a ring expander tool.
  3. Remove the No. 2 (intermediate) piston ring using a ring expander tool.
    GC0081637Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Typical piston shown in illustration. Do not use a piston ring expander to remove the oil ring side rails.

  4. Remove the oil ring upper side rail.
  5. Remove the oil ring lower side rail.
  6. Remove the oil ring expander (1).
scientia non olet · About LEMON Manuals