LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (3.6L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Removal

Damper, Vibration: Removal

WARNING: This page is about a different variant/trim than selected.
GC0144221Courtesy of CHRYSLER GROUP, LLC
  1. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
    NOTE:

    A force greater than 350 N.m (260 ft. lbs.) may be required to remove the crankshaft vibration damper bolt.

  2. Hold the crankshaft vibration damper (1) with Vibration Damper Holder (special tool #10198, Holder, Vibration Damper) (2) and remove the crankshaft vibration damper bolt.
  3. Pull the crankshaft vibration damper (1) off of the crankshaft.
scientia non olet · About LEMON Manuals