On Vehicle
WARNING: This page is about a different variant/trim than selected.
- If removed, install the spring seat and valve guide seal over the valve guide. Refer to REMOVAL .NOTE:
Make sure that the valve spring is intact around the top of the valve guide seal.
NOTE:If the valve springs are being reused, reassemble them into their original locations. Number 5 cylinder exhaust valve spring shown in illustration, all other valves similar.
- Install the valve spring (2) and valve spring retainer (1).NOTE:
Number 4 cylinder intake valve spring compression shown in illustration, all other valves similar.
- Compress the valve springs (4) with the (special tool #10224, Adapter, Valve Spring) (3) mounted in the (special tool #MD998772A, Compressor, Valve Spring) (2).
- Install the valve retaining locks (5) and release the valve spring compressor.
- Relieve the air pressure from the combustion chamber and remove the spark plug adapter (1).
- Install the spark plug. Refer to SPARK PLUG, INSTALLATION
.NOTE:
If the rocker arms are being reused, reassemble them into their original locations.
- Install the rocker arm(s). Refer to INSTALLATION .
- Remove the Camshaft Phaser Holder.
- Install the cylinder head covers. Refer to COVER(S), CYLINDER HEAD, INSTALLATION .