Body, Air Cleaner: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the air cleaner body (1) straight down on the locating pins while routing the air inlet under the hood seal (2).
- Install the push pin (3).
- Engage the hose retainer (5) to the air cleaner body.
- Install the fresh air makeup hose (4) to the air cleaner body.
- Install the resonator to the air cleaner body and the throttle body engaging the rubber grommets (3).
- Tighten the clamp at the throttle body (1) and the air cleaner body (2) to the proper specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the electrical connector (1) to the Inlet Air Temperature (IAT) sensor.
- Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
- Connect the negative battery cable.