LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (3.6L - DTCS P0344 To P0573) >> DTC Troubleshooting >> P0573-Brake Switch 1 Stuck Off >> Possible Causes

Possible Causes

WARNING: This page is about a different variant/trim than selected.
Possible Causes
BPP SENSOR NOT CALIBRATED
5-VOLT SUPPLY CIRCUIT OPEN OR SHORTED
BPP POSITION SIGNAL CIRCUIT SHORTED TO VOLTAGE
BPP POSITION SIGNAL CIRCUIT SHORTED TO THE 5-VOLT SUPPLY CIRCUIT
BPP SENSOR SIGNAL CIRCUIT OPEN/HIGH RESISTANCE
BPP SENSOR RETURN CIRCUIT OPEN/HIGH RESISTANCE
BRAKE PEDAL POSITION (BPP) SENSOR
ANTI LOCK BRAKE CONTROL MODULE

Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to  PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE  .