LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Emissions Control - 3.6L) >> Exhaust Gas RECIRCULATION >> Valve, Exhaust Gas RECIRCULATION (EGR) >> Installation

Valve, Exhaust Gas RECIRCULATION (EGR): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW  gasket onto the EGR valve.
    GC0173585Courtesy of CHRYSLER GROUP, LLC
  2. Install the EGR valve and tighten the nuts (1) to the proper specifications. Refer to EXHAUST GAS RECIRCULATION, TECHNICAL SPECIFICATIONS .
    GC0173683Courtesy of CHRYSLER GROUP, LLC
  3. Connect the EGR cooler hose (1) to the EGR valve and secure the clamp.
  4. Connect the EGR valve wire harness connector.
  5. Install the engine cover. Refer to COVER, ENGINE, INSTALLATION .
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals