LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Durango Pursuit >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Emissions Control - 3.6L) >> Exhaust Gas RECIRCULATION >> Sensor, EGR Temperature >> Removal

Sensor, EGR Temperature: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL .
  2. Disconnect and isolate the negative battery cable.
    GC0173589Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the EGR temperature sensor wire harness connector (1).
    GC0173629Courtesy of CHRYSLER GROUP, LLC
  4. Remove the EGR temperature sensor (1) from EGR cooler.
scientia non olet · About LEMON Manuals