Unit, ELECTROHYDRAULIC Control: Removal

WARNING: This page is about a different variant/trim than selected.

Courtesy of CHRYSLER GROUP, LLC

1 - PLUG CONNECTOR

2 - ADAPTER PLUG

Disconnect 13-pin plug connector (1). Turn bayonet lock of the adapter plug (2) anti-clockwise.

Courtesy of CHRYSLER GROUP, LLC

1 - HEAT SHIELD

2 - ELECTROHYDRAULIC UNIT

3 - BOLT

4 - OIL FILTER

5 - OIL PAN

6 - CLAMPING ELEMENT

7 - BOLT

8 - 13-PIN PLUG CONNECTOR

9 - BOLT

10 - ADAPTER PLUG

Loosen the adapter plug bolt (9) and remove from the adapter plug (10) from the transmission housing.
Detach oil pan (5).
Remove oil filter (4).
Unscrew Torx® socket bolts (3) and remove electrohydraulic control module (2).