Shifter - Floor Mount
WARNING: This page is about a different variant/trim than selected.
- If a new shifter assembly is being installed, use a trim stick (1) to separate the shift knob lower trim (3) from the shift knob (2).
- Pull up on the shift knob (1) to remove the knob from the shaft then remove the lower trim (2).
- Install the lower trim onto the new shifter shaft. Install the shift knob onto the shaft by hand. Install the lower trim onto the shift knob.
1 - SHIFTER ASSEMBLY 2 - NUTS 3 - GEARSHIFT CABLE - Install shifter assembly (1) onto the shifter assembly studs on the floor pan.
- Install the nuts (2) to hold the shifter assembly (1) onto the floor pan. Tighten nuts to 7 N.m (65 in.lbs.).
1 - GEARSHIFT CABLE 2 - CABLE RETAINER AND NOTCH 3 - SHIFTER ASSEMBLY PIN 4 - SHIFT LEVER 5 - ADJUSTMENT BOLT - Place the floor shifter lever in PARK position.
- Loosen the adjustment screw (5) on the gearshift cable (1).
- Install the gearshift cable (1) to the shift lever pin (3).
1 - SHIFTER ASSEMBLY 2 - WIRING CONNECTORS - Install the wiring harness connectors (2) to the shifter assembly.
- Verify that the shift lever is in the PARK position and the transmission park sprag is set by rocking the vehicle.
- Tighten the adjustment screw to 7 N.m (65 in.lbs.).
- Verify correct shifter, park lock, and BTSI operation.
- Install any console parts removed for access to shift lever assembly and shift cables. Refer to CONSOLE, FLOOR, INSTALLATION .