LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Charger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Nag1 Automatic Transmission (Service Information)) >> Seal, Output Shaft >> Removal

Seal, Output Shaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the propeller shaft. Refer to REMOVAL . Move propeller shaft to the right and tie up.
  2. If AWD equipped, remove the transfer case. Refer to REMOVAL . Proceed to step 5.
  3. Verify that the transmission is in PARK in order to prepare for the removal of the output shaft nut.
    NOTE:

    When removing the propeller shaft flange be certain the shim remains on the output shaft.

  4. Remove the nut, with a 30 mm 12 point socket, holding the propeller shaft flange to the output shaft and remove the flange.
  5. Remove the output shaft seal with suitable screw and slide hammer.
scientia non olet · About LEMON Manuals