LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Charger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Nag1 Automatic Transmission (Service Information)) >> GEARTRAIN, Planetary >> Disassembly

GEARTRAIN, Planetary: Disassembly

WARNING: This page is about a different variant/trim than selected.
Fig 1: Output Shaft With Center And Rear Planetary Gear Exploded View
GC0081290Courtesy of CHRYSLER GROUP, LLC
1 - TEFLON RINGS
7 - DRIVING CLUTCH K3
2 - OUTPUT SHAFT WITH CENTER PLANETARY CARRIER
8 - THRUST WASHER
3 - NEEDLE BEARING
9 - AXIAL NEEDLE BEARING
4 - THRUST WASHER
10 - SHIM
5 - REAR PLANETARY GEAR SET
11 - RETAINING RING
6 - REAR HOLLOW SHAFT/FREEWHEELING CLUTCH F2
  1. Remove upper two visible Teflon rings (1) from output shaft.
  2. Remove retaining ring (11), shim (10), thrust needle bearing (9) and thrust washer (8) from output shaft.
  3. Remove clutch K3 (7).
  4. Remove rear tubular shaft/freewheeling clutch F2 (6) from output shaft.
  5. Remove rear gear set (5) with integrated tubular shaft of center gear set from output shaft.
  6. Remove thrust washer (4).
scientia non olet · About LEMON Manuals