LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Charger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Nag1 Automatic Transmission (Service Information)) >> Cable, Shift >> Installation >> Column Mount

Column Mount

WARNING: This page is about a different variant/trim than selected.
GC0095832Courtesy of CHRYSLER GROUP, LLC
  1. Route the shifter cable through the dash panel (4), and install the shifter cable grommet (3) into the hole into the dash panel (4).
    GC0154682Courtesy of CHRYSLER GROUP, LLC
  2. Reconnect the shift cable (3) to the ball stud (2).
  3. Reconnect the shift cable (3) to the cable bracket.
  4. Place shifter into PARK.
  5. Raise vehicle.
    NOTE:

    The transmission must be in PARK.

    GC0095837Courtesy of CHRYSLER GROUP, LLC
  6. Route shifter cable (1) through the mounting bracket (2).
  7. Engage the gearshift cable (1) eyelet onto the transmission manual shift lever (3).
  8. Install the gearshift cable retaining clip (4) (if equipped).
  9. Lower the vehicle.
  10. Verify the transmission shifts in and out of PARK, and through all gear ranges. If necessary, adjust the cable. Refer to CABLE, SHIFT, ADJUSTMENTS .
    GC0095831Courtesy of CHRYSLER GROUP, LLC
  11. Install the silencer panel (1), and the silencer panel fasteners.
    GC0080510Courtesy of CHRYSLER GROUP, LLC
  12. Install the instrument panel steering column cover reinforcement (1) to the bracket (2), and install the screws (3).
  13. Reconnect the trunk release harness connector to the trunk release switch on the knee bolster.
  14. Install the knee bolster.
  15. Install the knee bolster fasteners.
  16. Install the instrument panel side trim at the end of the instrument panel.
scientia non olet · About LEMON Manuals