LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2018 >> Charger SXT Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (BW44-40 Transfer Case (Service Information)) >> Seal, Input Shaft >> Removal >> Rear

Seal, Input Shaft: Removal: Rear

WARNING: This page is about a different variant/trim than selected.
  1. Remove the rear propeller shaft. Refer to REMOVAL .
    GC0095862Courtesy of CHRYSLER GROUP, LLC
  2. Install (special tool #6958, Wrench, Spanner) Spanner Wrench (1) onto the rear output flange (2).
  3. Remove the rear output flange nut.
    GC0095863Courtesy of CHRYSLER GROUP, LLC
  4. Remove the rear output flange washer (1).
    GC0095864Courtesy of CHRYSLER GROUP, LLC
  5. Remove the outer rear output shaft seal (1).
    GC0095865Courtesy of CHRYSLER GROUP, LLC
  6. Remove the rear output flange (1).
  7. Remove the inner rear input shaft seal.
scientia non olet · About LEMON Manuals