Diagnostic Test

CHECK FOR AN ACTIVE DTC
1. Turn the ignition on and open one of the front doors.
  NOTE:
  A front door must remain open whenever checking or erasing Amplifier DTCs.
2. With the scan tool, read Amplifier DTCs and record on the repair order.
3. With the scan tool, erase DTCs.
4. Cycle the ignition switch from on to off, wait five seconds and then back to on.
5. Turn the Radio on.
6. Adjust the speakers to the rear and center.
7. With the scan tool, read Amplifier DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension. If no problems are found, test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE OPERATION OF THE LEFT REAR DOOR SPEAKER
1. Turn the ignition off.
2. Disconnect the Left Rear Door Speaker harness connector.
3. Turn the ignition on.
4. Turn the Radio on and turn the volume to 25.
5. Adjust the speakers to the rear and center.
6. With a Voltmeter set to read in A/C voltage, measure the voltage of the Left Rear Door Speaker circuits in the Left Rear Door Speaker harness connector.
  Is the voltage present greater than 1.0 Volt?
  
  Yes
  - Replace the Left Rear Door Speaker in accordance with the Service Information. Refer to SPEAKER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (X205) LEFT REAR DOOR SPEAKER (+) CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the Amplifier C2 harness connector.
3. Measure the resistance of the (X205) Left Rear Door Speaker (+) circuit between the Amplifier C2 harness connector and the Left Rear Door Speaker harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the (X205) Left Rear Door Speaker (+) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (X295) LEFT REAR DOOR SPEAKER (-) CIRCUIT FOR AN OPEN
1. Measure the resistance of the (X295) Left Rear Door Speaker (-) circuit between the Amplifier C2 harness connector and the Left Rear Door Speaker harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Replace the Amplifier in accordance with the Service Information. Refer to AMPLIFIER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the (X295) Left Rear Door Speaker (-) circuit for an open.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .