Module, Integrated Center Stack (ICSM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the Integrated Center Stack (ICS) to the bezel panel and install the four screws (1).

   Courtesy of CHRYSLER GROUP, LLC

2. Connect the wiring harness connector to the back of the ICS and snap the ICS back into the installed position.

   Courtesy of CHRYSLER GROUP, LLC

3. Align the storage bin (1) and push in to engage the two retaining clips.
4. Install the screws (2) and tighten securely.
5. Position the shifter bezel and use hand pressure to engage the retaining tabs.

   Courtesy of CHRYSLER GROUP, LLC

6. Position the shifter bezel (1) and use hand pressure to engage the retaining tabs.
7. Install the shifter knob (2) and install the screw (4). Tighten the screw securely.
8. Connect the wire harness connector (3).
9. Connect the negative battery cable.