Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read Heated Seat Module (HSM) DTCs and record on the repair order.
2. With the scan tool, erase HSM DTCs.
3. Turn the ignition off.
4. Start the Engine.
  NOTE:
  Both seat heaters should be in the OFF position and remain OFF for the results of the test to be valid.
5. With the scan tool, read HSM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Go To 4
CHECK THE (P187) LEFT FRONT SEAT HEATER CONTROL CIRCUIT FOR A SHORT TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the Heated Seat Module (HSM) C2 harness connector.
3. Start the Engine.
4. Measure the voltage between ground and the (P187) Left Front Seat Heater Control circuit at the HSM C2 harness connector.
  Is the voltage above 5.0 volts?
  
  Yes
  - Repair the (P187) Left Front Seat Heater Control circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE (P187) LEFT FRONT SEAT HEATER CONTROL CIRCUIT FOR A SHORT TO VOLTAGE DURING SEAT ADJUSTMENT
1. Measure the voltage between ground and the (P187) Left Front Seat Heater Control circuit at the HSM C2 harness connector while adjusting the seat in all positions.
  Is the voltage above 5.0 volts any time during the seat adjustment?
  
  Yes
  - Repair the (P187) Left Front Seat Heater Control circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Heated Seat Module (HSM) in accordance with the Service Information. Refer to MODULE, HEATED SEAT, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit. Wiggle the wiring and connectors while checking for shorted and open circuits. Attempt to reproduce the condition by adjusting the seat.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.