Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
NOTE:
Make sure the battery is fully charged and the charging system is operating properly before proceeding.
1. Turn the ignition on.
2. With the scan tool, read Heated Seat Module (HSM) DTCs and record on the repair order.
  NOTE:
  It is recommended to record any Environmental Data to help identify the conditions in which the DTC was set.
3. With the scan tool, erase HSM DTCs.
4. Turn the ignition off.
5. Start the Engine.
6. With the scan tool, read HSM DTCs.
  Does the DTC return?
  
  Yes
  - Go To 2
  No
  - Go To 4
CHECK THE (F922) FUSED IGNITION CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the HSM C3 harness connector.
3. Start the Engine.
4. With a 12-volt test light connected to ground, check the (F922) Fused Ignition circuit at the HSM C3 harness connector.
  NOTE:
  The test light must illuminate brightly. Compare the brightness to that of a direct connection to the battery.
  
  Does the test light illuminate brightly?
  
  Yes
  - Go To 3
  No
  - Repair the (F922) Fused Ignition Switch Output circuit for an open or high resistance.
    NOTE:
    If the fuse is open, make sure to check for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE (Z909) GROUND CIRCUIT FOR AN OPEN
1. Turn the ignition off.
2. Disconnect the HSM C1 harness connector.
3. With a 12-volt test light connected to 12 volts, check the (Z909) Ground circuit at the HSM C1 harness connector.
  Does the test light illuminate brightly?
  
  Yes
  - Replace the Heated Seat Module (HSM) in accordance with the Service Information. Refer to MODULE, HEATED SEAT, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Repair the (Z909) Ground circuit for an open or high resistance.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit. Wiggle the wiring and connectors while checking for shorted and open circuits. Attempt to reproduce the condition by adjusting the seat(s).
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. With the scan tool, check for any Environmental Data to help identify the conditions in which the DTC was set.
5. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.