Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- Turn the Radio and VES system on.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK THE HDMI CABLE AND AUXILIARY AUDIO VIDEO PORT FOR ANY CONCERNS
- Turn the ignition off.
- Disconnect the HDMI Cable at the Auxiliary Audio Video Port harness connector.
- Disconnect the VES2 HDMI module connector.
- Inspect terminals for any concerns at the Auxiliary Audio Video Port and check the HDMI Cable for any concerns.
Is there any damage to related terminals, connections, or HDMI Cable?
Yes
- Replace the HDMI Cable or the Auxiliary Port that has the concern. Refer to MEDIA HUB, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3
- CHECK FOR AN ACTIVE DTC
- Reconnect all connectors and turn the ignition on.
- Turn the Radio and VES system on.
- With the scan tool, read DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the VES2 Module in accordance with the service information. Refer to MONITOR, MEDIA SYSTEM, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .