Check For Can Bus Communication DTCS

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

WITH THE SCAN TOOL CHECK FOR CAN BUS COMMUNICATION DTCS.

Are there any CAN BUS COMMUNICATION DTCS present?

Yes

NOTE:

Check connectors - Clean and repair as necessary.

Check CAN Bus Communication lines for possible open or short. Repair the Wiring harness in accordance to the Service Information. Refer to DIAGNOSIS AND TESTING . Recheck the Scan tool, If DTC U142A-00- IMPLAUSIBLE PRNDL SIGNAL RECEIVED is active or any CAN BUS DTCS are active. Refer to DTC INDEX and perform the appropriate diagnostic procedure.
Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .

Check that the transmitting ECU (powertrain control module or transmission controller) is communicating. Refer to RESTRAINT SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST . With the Scan Tool recheck for communication from the specific module or modules. If communication is Inactive, refer to Non-DTC Diagnostics/Communication. Refer to DTC INDEX .