LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Occupant Restraint Controller (Orc) - DTCS B2208-00 To U1601-00) >> DTC Troubleshooting >> B2736-78-Left Pedestrian Protection Satellite Sensor Alignment Or Adjustment Incorrect >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR AN ACTIVE DTC 
    1. With the scan tool, read ORC DTCs and record on the repair order.
    2. Record the Environmental Data.
    3. With the scan tool, erase DTCs.
    4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    5. With the scan tool, read ORC DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
      • Probing of the circuit cavities at the ORC Module body harness connectors or vehicle connectors is only to be done with a approved test lead from the test lead 10159-6 or the use of Breakout Box 8443-55 to prevent vehicle wiring harness connector damage during diagnostic procedures. 
  2. INSPECT THE PEDESTRIAN PROTECTION SATELLITE SENSOR ALIGNMENT, FOR INCORRECT INSTALLATION OR DAMAGE 
    NOTE:

    If available, check the vehicle repair history for collision damage. Such as a low speed impact with no system deployment and now there is damage.

    WARNING:

    Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    1. Turn the ignition off.
    2. Inspect the front end of the vehicle covering fascia, grille, and looking under vehicle for possible damage. Pay extra attention to the pedestrian protection sensor areas for possible damage.
    3. Inspect the torque of the suspect sensor for a possible loose connection.

      Were any problems found?

      Yes 

      • Repair as necessary. Test drive vehicle to recreate road vibration to confirm repair. Reset the ORC module. Perform the ORC module reset. Access the Diagnostic Procedures menu from the ORC ECU Overview screen on the scan tool to perform this operation. Perform this operation if the DTC is stored, Repair as necessary and perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST . If the DTC is still active, replace the ORC. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
      • Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .

      No 

scientia non olet · About LEMON Manuals