Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

CHECK COMMUNICATION BETWEEN THE SCCM AND THE SPEED CONTROL SWITCH ASSEMBLY
1. Turn the ignition on.
2. With the scan tool, read DTCs in the SCCM.
  Is the SCCM reporting any Speed Control Switch or a Loss of Communication fault with the Speed Control Switch Assembly?
  
  Yes
  - Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic test.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Go To 2
CHECK FOR AN ACTIVE DTC
1. Cycle the ignition off and back to on.
2. With the scan tool, read active DTCs.
  Is this DTC active?
  
  Yes
  - Go To 3
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
OTHER COMMUNICATION DTCS PRESENT
1. With the scan tool continue reading PCM DTCs.
  Is the PCM reporting any other Lost Messages or Implausible Data DTCs?
  
  Yes
  - Replace the Powertrain Control Module in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL, REMOVAL .
  - Perform the Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
  No
  - Wiggle test and check the connector at the SCCM for an intermittent loose connection. If the wiring and connector tests good, replace and program the Steering Column Control Module (SCCM) in accordance with the Service Information. Refer to MODULE, STEERING COLUMN CONTROL (SCCM), REMOVAL .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .