LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2015 >> Durango SXT, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (Power Distribution) >> Center, Power Distribution (PDC) >> Removal >> Removal - PDC Assembly

Removal - PDC Assembly

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the PDC cover.
  3. Disconnect the power feed connections from the PDC.
  4. Release the plastic tabs that secure the PDC to the tray.
  5. The PDC upper tray will now lift upward. Carefully lift tray and disconnect the three bulkhead connectors from the bottom.
  6. Remove the PDC tray from the vehicle.
scientia non olet · About LEMON Manuals