Lamp, Side Repeater: Installation: Lamp
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Repeater lamps are used only on vehicles manufactured for certain markets where these lamps are required.
- Position the repeater lamp lens/housing (1) close enough to the fender mounting hole (3) to access and reconnect the wire harness connector (2) to the bulb socket on the back of the lamp lens/housing.NOTE:
The same repeater lamp is used on both sides of the vehicle. Regardless of which side of the vehicle the lamp is on, when properly oriented the fixed hook tab integral to the back of the lamp housing engages the edge of the fender mounting hole that is not notched and the latch feature engages the edge of the fender mounting hole that is notched.
- With the lamp lens/housing properly oriented, engage the hook tab on the back of the lamp with the edge of the fender mounting hole that is not notched.
- Using hand pressure, press the latch side of the lamp lens/housing into the notched edge of the fender mounting hole against the spring pressure of the latch feature until the latch snaps into place.
- Reconnect the battery negative cable.