Installation - SRT Only

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The Daytime Running Lamps (DRL) for non-SRT vehicles are integral to the front lamp units.

Fig 1: Daytime Running Lamp (DRL), Five Screws, Front Fog Lamp Bracket & Two Screws

Courtesy of CHRYSLER GROUP, LLC

Position the front fog lamp bracket (3) to the outboard end of the Daytime Running Lamp (DRL) housing (1).
Install and tighten the two screws (4) that secure the front fog lamp bracket to the DRL housing. Tighten the screws securely.
Position the DRL and the front fog lamp onto the back of the front fascia (5) as a unit.
Install and tighten the five screws (2) the DRL and the front fog lamp bracket to the back of the front fascia. Tighten the screws securely.
Reconnect the wire harness connections to the DRL and the front fog lamp bulb on the back of the front fascia.
Reinstall the fascia onto the front of the vehicle. Refer to FASCIA, FRONT, INSTALLATION .
Reconnect the battery negative cable.
Confirm proper fog lamp alignment. Refer to STANDARD PROCEDURE .