Switch And Lamp, Glove Box: Installation: Bulb
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.
CAUTION:
Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.
- Reach through the window (3) in the instrument panel glove box housing (1) to align the base of the bulb (4) with the bulb holder on the lower side of the glove box lamp and switch unit (2).
- Push the bulb straight into the bulb holder until the base is firmly seated.
- Close the glove box.
- Reconnect the battery negative cable.