Nozzle, Washer: Removal: Rear
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
- Using a trim stick or another suitable wide flat-bladed tool, gently pry the rear washer nozzle (3) to release the latch features that secure it in the mounting hole of the liftgate spoiler (2).
- Pull the rear washer nozzle out from the spoiler far enough to access the washer supply line (1).
- Disconnect the supply line from the barbed nipple on the back of the nozzle.
- Cut 4 to 6 millimeters (0.15 to 0.23 inch) from the end of the supply line to ensure a good fit to the barbed nipple of the rear washer nozzle when it is replaced or reinstalled.