Diagnostic Test

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

DETERMINE ACTIVE OR STORED DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. Perform ORC module reset. Access the Miscellaneous Function menu from the ORC ECU Overview screen on the scan tool to perform this operation.
3. Using the scan tool, read ORC DTCs.
  Is the DTC active or stored?
  
  ORC - ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
  - Go To 2
  ORC - STORED DTC
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK FOR ADDITIONAL ACTIVE SQUIB DTCS
1. Using the scan tool, read ORC DTCs.
  Are there squib specific DTCs set as active in addition to B0004-9A-DRIVER KNEE BOLSTER SQUIB- COMPONENT OR SYSTEM OPERATING CONDITIONS?
  
  Yes
  - Repair all other active squib specific DTCs before repairing B0001-9A-DRIVER FRONTAL SQUIB 1 - COMPONENT OR SYSTEM OPERATING CONDITIONS.
  No
  - Go To 3
USE THE SCAN TOOL TO IDENTIFY THE COUPLED CIRCUITS
1. Using the scan tool, identify the two or more Squib circuits that read SET.
  Are two or more Squib circuits DTCs set?
  
  Yes
  - Repair the two or more Squib circuits for a Squib Circuit Coupling condition.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .