Second Row Bucket - Left Or Right

WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.

Fig 1: Inner Hinge And Latch Bracket, Screw & Second Row Right Outboard Buckle

Courtesy of CHRYSLER GROUP, LLC

Fold and tumble the right or left second row bucket seat to which the buckle being serviced is secured.
Unsnap and remove the trim cover from the outside of the inboard hinge and latch bracket (1) of the second row bucket seat.
Remove the screw (2) that secures the buckle (3) lower anchor to the outside of the right or left second row bucket seat hinge and latch bracket.
Remove the buckle from the second row bucket seat hinge and latch bracket.