Diagnostic Test
WARNING: This page is about a different car, the 2016 Dodge Durango. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
NOTE:
This DTC must be active for the results of this test to be valid. Check for a loose scan tool connection. Verify battery charger is installed and charge rate provides approximately 13.5 volts.
- Turn the ignition on.
- With the scan tool, read DTCs and record on vehicle work order.
- With the scan tool, erase DTCs.
- With the scan tool, read EPS DTCs.
Is the DTC active?
Yes
- Replace the Electric Power Steering (EPS) Module in accordance with the Service Information. Refer to GEAR, REMOVAL .
- Perform EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform EPS VERIFICATION TEST. Refer to STANDARD PROCEDURE .